Job Description

2nd Shift runs from 3:15 p.m. - 11:45 p.m., Monday - Friday. Overtime will often be available during the week. Training may take place on 1st shift or mid-shift for the first 4 - 6 weeks.

SUMMARY OF FUNCTIONS

Actively involved in all duties for procedures related to operate machines to drill and/or rout panel boards.

ESSENTIAL DUTIES AND RESPONSIBILITIES

• Position panels on machine table, flush and aligned with tooling holes, start operation and remove boards at the end of the cycle.
• Check processed parts against template.
• Check tool sizes, remove and replace reset tools in magazine. Replace broken tools as required.
• Obtain and put away drills, mark drills that need to be re-sharpened.
• Notify supervisor of unusual equipment or operating difficulties.

Requirements

QUALIFICATIONS

A high school diploma is required.

PHYSICAL DEMANDS

Standing for long periods of time is required.

Exertion of up to 50 lbs. of force occasionally may be required. Good manual dexterity for the use of common office equipment such as computer terminals, calculator, copiers, and FAX machines.

Use of small drill bits; dexterity required.

WORK ENVIRONMENT

This position is in a manufacturing setting with exposure to noise, dirt and chemicals.

WORK SCHEDULE

Training may take place on one of three shift for the first 4 - 6 weeks based on performance:

1st shift training: 7:00 a.m. - 3:30 p.m.

Mid shift training: 11:00 a.m. - 7:30 p.m.

Permanent schedule would be 3:15 p.m. - 11:45 p.m., Monday - Friday with some overtime available during the week.